Allied Telesis AT-S25 - Manual (Page 109)

AT-S25 Management Software User’s Guide
109
Displaying Port’s STP Status and Setting
To display a port’s STP status and settings, perform the following
procedure:
1. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
2. Type S to select STP.
3. Type 3 to select STP Configuration. The STP Menu in Figure 36 on page
105 is displayed.
4. From the STP Menu, type P to select STP Port Parameters. The STP Port
Parameters window in Figure 37 on page 107 is displayed.
5. From the STP Port Parameters window, type M if you wish to select a
module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
6. Enter the ID of the module you wish to select, and press the Enter key.
7. In the STP Port Parameters window, type 2 to select Display STP Port
Configuration. The Display STP Port Configuration window in Figure
39 is displayed.
Figure 39 Display STP Port Configuration Window
The parameters displayed in this window are for viewing
purposes only. For description of the parameters, refer to Table 9,
STP and RSTP Parameters on page 102.