Allied Telesis AT-S25 - Manual (Page 110)

Section II: Local and Telnet Mangement
110
Configuring RSTP
This section contains the following procedures:
❑ Configuring a Bridge’s RSTP Settings on page 110
❑ Configuring a Port’s RSTP Settings on page 111
Configuring a
Bridge’s RSTP
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The default RSTP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how RSTP works might have a negative effect on your network. You
should consult the IEEE 802.1w standard before changing any of the
RSTP parameters.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu in Figure 35 on page 101 is displayed.
2. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
3. Type R to select RSTP.
4. Type 4 to select RSTP Configuration.
The RSTP Menu window in Figure 39 is displayed.
Figure 40 RSTP Menu