Allied Telesis AT-S25 - Manual (Page 85)

AT-S25 Management Software User’s Guide
85
Modifying a Port Trunk
To add or remove ports from a 10/100 Mbps port trunk, perform the
following procedure:
1. From the Main Menu, type 1 to select Ports Menu.
2. From the Ports Menu, type 3 to select Port Trunking.
The Port Trunking menu in Figure 29 on page 82 is displayed.
3. To modify a port trunk on a switch other than the one currently
selected, type M.
The following prompt is displayed:
Select Module ID: [1 to 8] ->
4. Enter the ID of the module you want to select, and press the Enter key.
5. From the Port Trunking menu, type 3 to select Modify 10/100 Trunk
Ports.
The following prompt is displayed.
Enter Trunk Number -> [1 to 5] ->
6. Enter the number of the port trunk you want to modify; then press the
Enter key.
The following prompt is displayed:
Enter trunk ports [1 - 8] ->
7. Enter the new port list for the trunk port. The new ports will overwrite
the old ports. You can specify the ports individually (e.g., 1,2,3,4), as a
range (e.g., 1-4), or both (e.g., 1-2,5,7).
8. Press any key to continue.
9. Type S to select Save Configuration Changes.