Allied Telesis AT-S25 - Manual (Page 177)

AT-S25 Management Software User’s Guide
177
Displaying Switch Statistics
To display Ethernet statistics for an entire switch, perform the following
procedure:
1. From the Main Menu, type 7 to select Ethernet Statistics.
2. From the Ethernet Statistics menu, type M if you wish to select a
module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
3. Enter the ID of the module you wish to select, and press the Enter key.
4. From the Ethernet Statistics menu, type 2 to select Display Module
Statistics.
The statistics for the switch are displayed in the Display Module
Statistics window, shown in Figure 68.
Figure 68 Display Module Statistics Window
The information in this window is for viewing purposes only. For
description of these parameters, refer to Table 16, Port and
Module Statistics Parameters on page 176.
5. If you wish to clear the counters on the switch and return them to “0”,
type 3 to select Clear Module Statistics” from the Ethernet Statistics
Menu.