Allied Telesis AT-S25 - Manual (Page 43)

AT-S25 Management Software User’s Guide
43
The basic switch parameters can be found in the Administration Menu,
as shown in Figure 10.
Figure 10 Administration Menu
Table 1 lists the basic switch parameters used in the Administration
Menu.
Table 1 Basic Switch Parameters
PARAMETER DESCRIPTION
1 - IP Address This parameter specifies the IP address of the stack.
You must specify an IP address if you intend to
remotely manage the stack using a Telnet utility, an
SNMP management program, or a Web browser.
2 - Subnet Mask This parameter specifies the subnet mask. You must
specify a subnet mask if you assigned an IP address to
the stack.
3 - Default
Gateway This parameter specifies the default router’s IP address.
This address is required if you intend to remotely
manage the stack from a management station that is
separated from the stack by a router.
4 - System Name This parameter specifies a name for the stack (for
example, Sales).
The value range is 1 to 39 alphanumeric characters.
This parameter is optional.
NOTE: Assigning names to the different stacks in your
network can make it easier for you to identify them.
This can help you avoid performing a configuration
procedure on the wrong stack.