Allied Telesis AT-S25 - Manual (Page 112)

Section II: Local and Telnet Mangement
112
6. From the RSTP Port Parameters window, type M if you wish to select
a module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
7. Enter the ID of the module you wish to select, and press the Enter key.
8. From the RSTP Port Parameters window, type 1 to select Configure
RSTP Port Settings.
The following prompt is displayed:
Start Port to configure [1 - 24] ->
9. Enter the number of the port you wish to configure. To configure a
range of ports, enter the first port of the range. Press the Enter key.
The following prompt is displayed:
End Port to Configure [1 - 24] ->
❑ To configure just one port, enter the same port number here as
you entered in the previous step.
❑ To configure a range of ports, enter the last port of the range.
10. Press the Enter key.
The Configure RSTP Port Settings menu in Figure 42 on page 112
is displayed.
Figure 42 Configure RSTP Port Settings Menu