Allied Telesis AT-S25 - Manual (Page 49)

AT-S25 Management Software User’s Guide
49
Pinging a Remote System
You could instruct the switch to ping a remote device on your network.
This procedure is useful in determining whether a valid link exists
between the switch and another device.
To ping a network device, perform the following procedure:
1. From the Main Menu, type 4 to select Administration Menu.
The Administration Menu as shown in Figure 10 on page 43 is
displayed.
2. From the Administration Menu, type P to select Ping a Remote System.
The following prompt is displayed:
Please enter an IP address ->
3. Enter the IP address of the end node you wish the switch to ping and
press the Enter key.
The results of the ping command are displayed on the screen. To
stop the ping, press any key.
For information on this parameter setting, refer to Table 1 on
page 43.