Allied Telesis AT-S25 - Manual (Page 63)

AT-S25 Management Software User’s Guide
63
8. Once you have set the port parameters, type S to select Save
Configuration changes.
Configuration changes take effect immediately on the switch.
B - Back
Pressure Sets back pressure on the port. This parameter only
applies to ports that are operating in half-duplex mode.
A port operating with back pressure transmits a JAM
pattern to halt the transmission of packets from the end
node when the port’s buffer is full and it cannot receive
any more packets.
Possible settings for this parameter are:
• Disable (default)
• Enable
PARAMETER DESCRIPTION