Allied Telesis AT-S25 - Manual (Page 111)

AT-S25 Management Software User’s Guide
111
5. Enter or modify the parameters in the RSTP Menu window as desired.
For description of the parameters displayed in this window, refer
to Table 9, STP and RSTP Parameters on page 102.
6. After adjusting the parameters, type S to select Save Configuration
changes.
Changes to the parameters take effect immediately on the switch.
Note
The aging time for BPDUs is different from the aging time used by
the MAC address table.
7. To reset a bridge’s RSTP settings to the default settings, type D.
8. To change the RSTP port settings, go to the next procedure.
Configuring a
Port’s RSTP
Settings
To adjust a port’s RSTP parameters, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
2. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
3. Type R to select RSTP.
4. Type 4 to select RSTP Configuration.
5. From the RSTP Configuration menu, type P to select RSTP Port
Parameters.
The RSTP Port Parameters menu in Figure 41 on page 111 is
displayed.
Figure 41 RSTP Port Parameters Menu