Allied Telesis AT-S25 User Manual
Page 73
AT-S25 Management Software User’s Guide
73
The Port Security Limited-Mode menu in Figure 23 is displayed.
Figure 23 Port Security Limited-Mode Menu
4. From the Port Security Limited-Mode menu, type M if you want to
configure the Limited security level on a switch other than the one
currently managing.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
5. Enter the ID of the module you want to select, and press the Enter key.
6. From the Port Security Limited-Mode menu, type 2 to select Set MAC
Threshold.
A prompt similar to the following is displayed:
Select Port Group ID [1 to 5] ->
7. Enter the number of the port group where you want to specify a new
MAC address limit. The port groupings for the AT-8300 Series
switches can be found in Port Groupings on page 69.
The following prompt is displayed:
Enter the MAC threshold value -> [1 to 1024] ->
8. Enter the maximum number of dynamic MAC addresses you want the
port group to be able to learn and press the Enter key. The range is 1
to 1024 addresses. The default is 100.
9. Repeat this procedure starting with Step 4 to specify MAC address
limits on other port groups.