Allied Telesis AT-S25 - Manual (Page 233)

AT-S25 Management Software User’s Guide
233
Configuring STP
Configuring a
Bridge’s STP
Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The bridge provides default STP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how STP works might have a negative effect on
your network. You should consult the IEEE 802.1d standard before
changing any of the STP parameters.
To configure STP, perform the following procedure:
1. From the Spanning Tree window in Figure 92 on page 228, click
Configure.
The STP Configuration Spanning Tree window is displayed in
Figure 92.
Figure 93 STP Configuration Spanning Tree Window