HP XP7 Storage - Manual (Page 74)

Table 15 Email details for system failures notice (continued)
Description Item #
Email address to which replies from the receivers will be sent. Optional. Reply-To 4
Email title (Name of the storage system) + (Report) Subject 5
Date when a system failure occurred. Date 6
Time when a system failure occurred. Time 7
Name and serial number of the storage system. Machine 8
Reference code. The same code as the one reported by SNMP traps. RefCode 9
Failure details. The same information as the one reported by SNMP traps. Detail 10
See the HP XP7 SNMP Agent User Guide for reference codes and failure details.
Setting system options
You can change settings about alert display and data acquisition by setting system options. Log
off and log in again when you enabled or disabled a system option.
Prerequisites
•
You must have the Storage Administrator (Initial Configuration) role to perform this task.
To set system options:
1.
Click Settings > Environmental Settings > Edit System Options.
2. Select the system option to set and click Enable.
•
Hide alert information. If you enable this system option, the Alert window does not open.
•
Refresh forcibly after Apply. If you enable this system option, after settings changes are
applied to the storage system, the configuration information for the storage system is
forcibly updated.
•
Disable data polling. If you enable this system option, polling stops.
•
Disable retry of data updating. If you enable this system option, retry does not occur even
if data cannot be acquired.
•
Enable Remote Web Console 2 All Function. If you enable this system option, the restrictions
on login from Remote Web Console's login window are cleared, including the restrictions
on the users who can log in and on the functions available after login. When enabling
or disabling the system option, log in again.
3. Click Finish. The Confirm window opens.
4. In the Confirm window, check the settings and enter a task name in Task Name.
5. Click Apply. The task is registered. If the Go to tasks window for status check box is checked,
the Task window opens.
Related Topics
•
“Edit System Options window” (page 227)
Setting Remote Web Console environmental parameters
You can set the following Remote Web Console environmental parameters:
•
Polling period for monitoring who is changing information while others are viewing
•
Time interval for monitoring disk controller and disk array unit status
74 Configuring the Remote Web Console environment