HP XP7 Storage - Manual (Page 217)

The following table describes the fields and settings in the SNMP tab.
Description Item
Select whether or not to use the SNMP Agent. Extension SNMP
•
Enable: Reports SIM through SNMP trap
•
Disable: Does not report SIM through SNMP trap
SNMP Trap Settings •
Community: Displays the community name for which SNMP trap is reported.
•
IP Address: Displays the IP address of the SNMP Manager for which an SNMP trap is set.
• SNMP Trap - Add: Adds an SNMP trap. The Add SNMP Trap window opens.
•
SNMP Trap - Change: Changes the IP address and community name for the SNMP Manager
for which SNMP trap is set. The Change SNMP Traps window opens.
• SNMP Trap - Delete: Deletes the selected SNMP trap. You can select more than one SNMP
trap.
•
Community - Add: Add a community. The Add Community window opens.
• Community - Change: Changes a community name. The Change Community window opens.
•
Community - Delete: Deletes the selected community. You can select more than one
community.
SNMP Manager • IP Address: Displays the IP address of the SNMP Manager.
•
Add: Adds an SNMP Manager. The Add SNMP Manager window displays.
• Delete: Deletes the selected SNMP Manager. You can select more than one SNMP Manager.
Enter the storage system name. You can enter up to 180 alphanumeric characters (ASCII codes)
excluding several symbols (\ , / ; : * ? ” < > | & % ^). Caution: Make sure to document the System Group Information -
Storage System Name
information about the storage system because the settings will be cleared when the SVP is
replaced.
Enter the administrator's name or contact information.You can enter up to 180 alphanumeric
characters (ASCII codes) excluding several symbols (\ , / ; : * ? " < > | & % ^). System Group Information -
Contact
Specify a location of the storage system. You can enter up to 180 alphanumeric characters
(ASCII codes) excluding several symbols (\ , / ; : * ? " < > | & % ^). System Group Information -
Location
Reports test trap to communities that are already registered in the storage system. SNMP Trap Test Send
Note: Trap is reported using the content applied previously to the storage system rather than
the current settings in the SNMP tab. Before reporting test trap, click Finish to apply the changes
to the storage system.
Edit Alert Settings wizard 217