HP XP7 Storage - Manual (Page 73)

6. Enter the following email server information:
•
Identifier. To specify a host name, select Identifier. You can use up to 63 alphanumeric
characters (ASCII codes) and symbols ("! # $ ` + - * ' { } _ . ).
•
IPv4. To set an IPv4 address, select IPv4, and enter four numbers within the range of 0
to 255.
Example: XXX.XXX.XXX.XXX (X indicates a numeral)
•
IPv6. To set an IPv6 address, select IPv6, and enter eight hexadecimal alphanumeric
characters within the range of 0 to FFFF. You can also use an abbreviated-format IPv6
address.
Example: YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY (Y indicates a hexadecimal
digit)
7. In SMTP Authentication, select Enable to use SMTP authentication. Select Disable to not use
SMTP authentication. If you select Enable, enter an account and password for SMTP
authentication.
You can use up to 255 alphanumeric characters (ASCII codes) and symbols (! # $ % & ` + -
* / ' ^ { } _ .).
This field is mandatory when you selected Enable in Mail Notice.
8. If necessary, click Email Test Send to test the settings.
9. Check that the test email has been received.
For a test email example and explanation, see Example of test email, below.
10. Click Finish. The Confirm window opens.
11. In the Confirm window, check the settings and enter a task name in Task Name.
12. Click Apply. The task is registered. If the Go to tasks window for status check box is checked,
the Task window opens.
Related Topics
•
“Edit Alert Settings window” (page 214)
Example of test email
Date: FRI 25 OCT 2013 10:10:10 +9000 (JST)
To: XP7 [email protected]
From: [email protected]
Reply-To: [email protected]
Subject: XP7 Report
Date : 25/10/2013
Time : 10:09:30
Machine : XP7(Serial# 64019)
RefCode : 7FFFFF
Detail: This is Test Report.
The field definitions in the test email are listed in the following table:
Table 15 Email details for system failures notice
Description Item #
Date and time when the email was sent. This time stamp is set by the mail server. Date 1
Email address of the receiver. To 2
Email address of the sender. From 3
Reporting failure information about storage systems 73