HP XP7 Storage - Manual (Page 220)

The following table describes the fields and settings in the Add SNMP Manager window.
Description Item
Specify the IP address of the SNMP Manager. You cannot use an address with all 0s. SNMP Manager
•
IPv4: To set an IPv4 address, select IPv4, and enter four numbers within the range of 0 to
255.
Example: XXX.XXX.XXX.XXX (X indicates a numeral)
•
IPv6:To set an IPv6 address, select IPv6, and enter eight hexadecimal alphanumeric characters
within the range of 0 to FFFF. You can also use an abbreviated-format IPv6 address.
Example: YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY (Y indicates a hexadecimal digit)
Add SNMP Traps window
The following table describes the fields and settings in the Add SNMP Traps window.
Description Item
Specify the IP address of the SNMP Manager. You cannot use an address with all 0s. IP Address
•
IPv4: To set an IPv4 address, select IPv4, and enter four numbers within the range of 0 to
255.
Example: XXX.XXX.XXX.XXX (X indicates a numeral)
•
IPv6: To set an IPv6 address, select IPv6, and enter eight hexadecimal alphanumeric
characters within the range of 0 to FFFF. You can also use an abbreviated-format IPv6
address.
Example: YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY, where Y indicates a hexadecimal
digit.
Set a community name for which SNMP traps are reported. You can issue traps (report from
the SNMP Agent to the SNMP Manager) to the IP address registered to the community. Community
You can register up to 32 communities. For community names, you can use up to 180
alphanumeric characters (ASCII codes) excluding these symbols: (\ , / ; : * ? " < > | & % ^
).
220 Configuring storage systems GUI reference