HP XP7 Storage - Manual (Page 221)

Change SNMP Traps window
The following table describes the fields and settings in the Change SNMP Traps window.
Description Item
Specify the IP address of the SNMP Manager. You cannot use an address with all 0s. IP Address
•
IPv4: To set an IPv4 address, select IPv4, and enter four numbers within the range of 0 to
255.
Example: XXX.XXX.XXX.XXX (X indicates a numeral)
• IPv6: To set an IPv6 address, select IPv6, and enter eight hexadecimal alphanumeric
characters within the range of 0 to FFFF. You can also use an abbreviated-format IPv6
address.
Example: YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY, where Y indicates a hexadecimal
digit.
Set a community name for which changed SNMP traps are reported. You can issue traps (report
from the SNMP Agent to the SNMP Manager) to the IP address registered to the changed
community. Community
You can register up to 32 communities. For community names, you can use up to 180
alphanumeric characters (ASCII codes) excluding these symbols: (\ , / ; : * ? " < > | & % ^
).
Add Community window
Use the change community window to add a new SNMP community.
Edit Alert Settings wizard 221