GW Instek GDS-200 Series Programming Manual - Manual (Page 90)

GDS-200 & GDS-300 Programming Manual
90
Run Command
:RUN
Description The run command allows the oscilloscope to
continuously make acquisitions, equivalent to
toggling the scope to RUN mode (using the
Run/Stop key on the LCD screen).
Syntax :RUN
Stop Command
:STOP
Description The stop command stops the oscilloscope making
further acquisitions, equivalent to toggling the
scope to STOP mode (using the Run/Stop key on
the LCD screen).
Syntax :STOP
Single Command
:SINGle
Description The single command allows the oscilloscope to
capture a single acquisition when trigger
conditions have been fulfilled (equivalent to
pressing the Single key on the screen).
Syntax :SINGle
Set
Set
Set