GW Instek GDS-200 Series Programming Manual - Manual (Page 119)

COMMAND DETAILS
119
Parameter/ OFF Pauses/Stops the test
Return Parameter ON Starts the test
Example :GONogo:EXECute OFF
Turns Go/NoGo off.
:GONogo:FUNCtion
Description Initializes the Go/NoGo function. This must be
run before any Go/NoGo commands can be used.
Syntax :GONogo:FUNCtion
:GONogo:NGCount
Description Returns the Go/NoGo counter.
Syntax :GONogo:NGCount?
Return parameter Returns a string in the following format “number of
violations,total tests”
Example :GONogo:NGCount?
> 3,25
Indicates that 3 violations occurred over 25 tests.
:GONogo:NGDefine
Description Sets the Go/NoGo “When” conditions.
Syntax :GONogo:NGDefine {EXITs|ENTers|?}
Parameter/
Return Parameter EXITs Sets the NoGo condition to when the
input signal exceeds the limit boundary.
ENTers Sets the NoGo condition to when the
input signal stays within the limit
boundary.
Example :GONogo:NGDefine EXITs
Sets the Go/NoGo condition to EXITs.
Set
Query
Set
Query