GW Instek GDS-200 Series Programming Manual - Manual (Page 28)

GDS-200 & GDS-300 Programming Manual
28
Acquisition Commands
:ACQuire:AVERage ...................................................... 28
:ACQuire:MODe .......................................................... 28
:ACQuire:MEMory? ............................................... 29
:ACQuire:STATe? .................................................. 29
:ACQuire:INTERpolation ............................................. 30
:ACQuire:RECOrdlength .............................................. 30
:HEADer ....................................................................... 31
:ACQuire:AVERage
Description Selects or returns the number of waveform
acquisitions that are averaged in the average
acquisition mode.
Syntax :ACQuire:AVERage {| ?}
Related
Commands :ACQuire:MODe
Parameter 2, 4, 8 ,16, 32, 64, 128, 256
Note Before using this command, select the average
acquisition mode. See the example below.
Example :ACQuire:MODe AVERage
:ACQuire:AVERage 2
Selects the average acquisition mode, and sets the
average number to 2.
:ACQuire:MODe
Description Selects or returns the acquisition mode.
Syntax :ACQuire:MODe {SAMPle | PDETect | AVERage | ?}
Related
Commands :ACQuire:AVERage
Set
Query
Set
Query