GW Instek GDS-200 Series Programming Manual - Manual (Page 75)

COMMAND DETAILS
75
Note Before using this command, select the
measurement channel. See the example below.
Example :MEASure:SOURce1 CH1
:MEASure:NEDGE?
1.100E+01
Selects Channel 1, and then measures the number
of negative edges.
:MEASure:FRRDelay
Description Returns the delay between the first rising edge of
source1 and the first rising edge of source2.
Syntax :MEASure:FRRDelay?
Related
Commands :MEASure:SOURce
Return parameter Returns the delay.
Chan Off Indicates the source channel is not
activated.
Note Select the two source channels before entering this
command.
Example :MEASure:SOURce1 CH1
:MEASure:SOURce2 CH2
:MEASure:FRRDelay?
-4.68E-6
Select channel 1 and 2 as source1/2, and then
measure FRR.
:MEASure:FRFDelay
Description Returns the delay between the first rising edge of
source1 and the first falling edge of source2.
Syntax :MEASure:FRFDelay?
Query
Query