GW Instek GDS-200 Series Programming Manual - Manual (Page 81)

COMMAND DETAILS
81
Measurement Commands
:MEASUrement:MEAS:SOURCE ....................81
:MEASUrement:MEAS:TYPe ................................ 82
:MEASUrement:MEAS:VALue.............................. 82
:MEASUrement:MEAS:MAXimum ...................... 83
:MEASUrement:MEAS:MEAN ............................. 84
:MEASUrement:MEAS:MINImum ...................... 84
:MEASUrement:STATIstics:MODe ............................ 85
:MEASUrement:STATIstics ........................................ 85
:MEASUrement:DISPlay ............................................. 86
:MEASUrement:MEAS:SOURCE
Description Sets or queries the measurement source for a
selected automatic measurement. This is a statistics
related command.
Syntax :MEASUrement:MEAS:SOURCE { CH1 | CH2 |
MATH | ? }
Related
commands :MEASUrement:MEAS:TYPe
Parameter MEAS The automatic measurement number
from 1 to 4.
SOURCE SOURCE1: Source#1 for all single
channel measurements.
SOURCE SOURCE2: Source#2 for all delay or
phase measurements.
CH1 to CH2 Channel 1, 2
MATH Math source
Return parameter CH1 to CH2 Channel 1, 2
MATH Math source
Set
Query