GW Instek GDS-200 Series Programming Manual - Manual (Page 104)

GDS-200 & GDS-300 Programming Manual
104
:TRIGger:ALTernate
Description Sets alternating between source triggers on or off
or queries its state.
Syntax :TRIGger:ALTernate {OFF | ON |?}
Parameter OFF Alternate off
ON Alternate on
Return parameter Returns the Alternate trigger status (ON, OFF).
Example :TRIGger:ALTernate ON
Turns on alternating between source triggers.
:TRIGger:STATe
Description Returns the current state of the triggering system.
Syntax :TRIGger:STATe?
Return parameter *ARMED Indicates that the oscilloscope is
acquiring pretrigger information.
*AUTO Indicates that the oscilloscope is in the
automatic mode and acquires data
even in the absence of a trigger.
*READY Indicates that all pretrigger
information has been acquired and
that the oscilloscope is ready to accept
a trigger.
*SAVE Indicates that the oscilloscope is in
save mode and is not acquiring data.
*TRIGGER Indicates that the oscilloscope
triggered and is acquiring the post
trigger information.
Example :TRIGger:STATe?
AUTO
The trigger is in auto mode.
Set
Query
Query