Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 609)

Fabric OS Command Reference 579
53-1003131-01
mapsConfig
2
circuit
The elements are FCIP circuits.
sfp
The elements are SFP transceivers.
-members member_list
Specifies the specific elements on which to pause or continue monitoring. The
member list must be enclosed in double quotation marks and can consist of the
following:
Port and SFP groups:
• A single port, for example, "8" or "2/8" on bladed systems.
•
A port range where the beginning and end port are separated by a dash,
for example, "8-13" or "2/8-13" on bladed systems.
• A set of ports and port ranges separated by commas, for example,
"3,5,7-10,15" or "2/3,2/5,3/7-10,4/15" on bladed systems.
Circuit groups:
• A single circuit in VE_Port/circuit format, for example, "33/5".
•
A circuit range in VE_Port/circuit format, for example, "33/1-3".
• A set of circuits separated by commas, for example, "33/1-3,33/5".
--actions actions_list
Specifies a comma-separated list of all of the actions that are allowed globally on
the switch. Any actions listed for a specific rule must also be listed here to take
effect. Valid actions include the following:
raslog
Generates a RASLog message.
decom
Decommissions the port. Use this action along with fence.
fence
Fences the port, if port fencing is enabled. Port fencing takes the ports offline if the
user-defined thresholds are exceeded. This action is valid only on conditions that
are evaluated on ports.
snmp
Generates an SNMP trap.
email
Sends information about a switch event to a specified e-mail address.
sw_critical
Sets the state of the affected switch to critical. This action is valid only if the
monitoring system (specified by the monitor operand in the mapsRule
command) is one of the switch policy status monitoring systems.
sw_marginal
Sets the state of the affected switch to marginal. This action is valid only if the
monitoring system (specified by the monitor operand in the mapsRule
command) is one of the switch policy status monitoring systems.
sfp_marginal
Sets the state of the affected SFP transceiver to marginal. This action is valid only
if the monitoring system (specified by the monitor operand in the mapsRule
command) is one of the switch policy status monitoring systems.
none
No actions are allowed on the switch. Specifying this option allows you to turn off
all notifications.