Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 302)

272 Fabric OS Command Reference
53-1003131-01
extnCfg
2
extnCfg
Sets the extension mode configuration.
SYNOPSIS
extncfg --ve | --ve-mode [slot/] 10VE | 20VE
extncfg --show
extncfg --help
DESCRIPTION
Use this command to set the extension mode configuration. This command switches the Field
Programmable Gate Array (FPGA) images or the VE_Port mappings.
NOTES The execution of this command is disruptive and requires the switch reboot.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
[slot/]
For bladed systems only, specifies the slot number of the port to be
configured,followed by a slash (/).
--ve | --ve-mode 10VE | 20VE
Switches the VE_Port mode between 10 VE-ports and 20 VE-ports. The default
VE_Port mode is 10VE.
-show
Displays the current extension mode configuration.
--help
Displays the command usage.
EXAMPLES
To display the current extension mode configuration:
switch:admin> extncfg --show
VE-Mode: configured for 10VE mode.
To switch the extension mode configuration:
switch:admin> --ve-mode 20VE
This operation will require a reboot of the switch and will disrupt
any running traffic.
Are you sure you want to proceed? (y/n): y
Operation Succeeded. Rebooting Switch.
SEE ALSO
None