Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 193
Fabric OS Command Reference
163
53-1003131-01
configure
2
Enforce FLOGI/FDISC login
Setting this flag allows a second F_Port login (FLOGI/FDISC login) in the event of
two devices attempting to log in with the same PWWN. In default mode (zero) the
first FLOGI/FDISC login takes precedence over the second. When the mode is set
to 1, the second FLOGI/FDISC login takes precedence over the first. All modes
are for NPIV and non-NPIV F-Ports. When mode is set to 2, on FLOGI login the
first FLOGI takes precedence. On FDISC login, the second FDISC takes
precedence. For more information, refer to "Configure FLOGI-time handling of
duplicate PWWNs" section in the Fabric OS Administrator's Guide. You must
disable the switch to change this parameter.
MAX num. of FLOGIs allowed
Specifies the number of FLOGIs the port can accept per second. The default
value is 100. When the FLOGI limit is reached, the port will be fenced.
Zoning Operation Parameters
The following zoning operation parameter can be modified.
Disable NodeName Zone Checking
Specify 1 to disable using node WWN when specifying nodes in the zone
database. Specify 0 to enable using node WWN when specifying nodes in the
zone data. The default value is 0. This value must be set to 1 for interpretability.
RSCN Transmission Mode
The RSCN transmission modes and values are as follows:
End-device RSCN Transmission Mode
Values are as follows:
0
RSCN only contains single PID
1
RSCN contains multiple PIDs (Default)
2
Fabric addresses RSCN
Domain RSCN to End-device
Values are as follows:
0
Disabled. No domain RSCN is sent to the end-device for the switch IP address or
name change.
1
Enabled. Domain RSCN is sent to the end-device for the switch IP address or
name change.
Arbitrated Loop Parameters
Arbitrated Loop Parameter and their values are as follows:
Send FAN frames?
Specifies that fabric address notification (FAN) frames be sent to public loop
devices to notify them of their node ID and address. When set to 1, frames are
sent; when set to 0, frames are not sent. The default value is 1.
Enable CLOSE on OPEN received?
If this is set, a CLS is returned immediately to an OPN if no buffers are available.
This is required for TachLite. The valid range is 0 to 4. The default value is 0.