Trunkdebug – Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 1198
1168
Fabric OS Command Reference
53-1003131-01
trunkDebug
2
trunkDebug
Debugs a trunk link failure.
SYNOPSIS
trunkdebug port1 port2
DESCRIPTION
Use this command to debug a trunk link failure. This command reports one of the following messages,
based on the trunking properties of the two specified ports:
•
Switch does not support trunking
•
Trunking license required
•
port port_id is not E_Port
•
port port_id trunking disabled
•
port port_id speed is not 2G, 4G or 8G
•
port port_id and port port_id are not in same port group
•
port port_id and port port_id connect to different switches
•
port port_id and port port_id connect to the switch WWN
•
port port_id is not a trunking port due to: E_Port being disabled, or trunking might be disabled at
remote port
•
port port_id and port port_id cannot trunk, please check link length to make sure difference is less
than 400 m
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
port1
Specify the port index number of port 1. Use the switchShow command to view
the index numbers for a port. This operand is required.
port2
Specify the port index number of port 2. Use the switchShow command to view
the index numbers for a port. This operand is required.
EXAMPLES
To debug a trunk connection:
switch:admin> trunkdebug 43 44
Switch does not support trunking
switch:admin> trunkdebug 62 63
port 62 and 63 are trunked together
SEE ALSO
,