Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 299)

Fabric OS Command Reference 269
53-1003131-01
ethIf
2
interface
Specifies the name of the interface, optionally enclosed in double quotation
marks. Valid interfaces include the following:
eth0 | eth3
Displays the link operating mode of the specified interface. The value eth3 is
valid only on the CP of a Brocade DCX or DCX-4S.
bond0
Displays the active Ethernet port. This operand is valid only on the CP of a
DCX or a DCX-4S.
-auto-negotiate | -an
Configures auto-negotiation.
on | off
Sets auto-negotiation on or off.
-speed speed
Configures the speed. You can configure 1000, 100, or 10 as the speed. Note that
1000 Mbps speed can be configured only when auto-negotiation is on.
-duplex
Configures whether the capability of operation is full duplex or half duplex.
--show
Displays the link operating mode for a network interface.
interface
Specifies the name of the interface, optionally enclosed in double quotation
marks. Valid interfaces include the following:
eth0 | eth3
Displays the link operating mode of the specified interface. The value eth3 is
valid only on the CP of a Brocade DCX or DCX-4S.
bond0
Displays the active Ethernet port. This operand is valid only on the CP of a
DCX or a DCX-4S.
--help
Displays the command usage.
EXAMPLES
To view the link operating attributes on bond0:
switch:admin> ethif --show bond0
bond0 interface:
bond0 includes physical interfaces: eth0 eth3
Currently Active Interface: eth0
Currently Slave Interface: eth3
Link mode: negotiated 1000baseT-FD, link ok
MAC Address: 00:05:1E:86:7B:79
bond0 Link encap:Ethernet HWaddr 00:05:1E:86:7B:79
inet addr:10.38.18.135 Bcast:10.38.31.255 Mask:255.255.240.0
UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1
RX packets:2373 errors:0 dropped:0 overruns:0 frame:0
TX packets:56 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0