Fcipledtest – Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual

Page 333

Fabric OS Command Reference

303

53-1003131-01

fcipLedTest

Exercises the GbE port LEDS on the Brocade 7800 and FX8-24.

SYNOPSIS

fcipledtest [slot | all]

DESCRIPTION

Use this command to exercise the GbE port LEDs on the Brocade 7800 and FX8-24. This test cycles
through the port LEDs by lighting GREEN and then flashing GREEN on all ports for 3 seconds. As the
test continues the ports turn AMBER and then flashing AMBER for 3 seconds. The LEDs turn off when
the test has finished.

This diagnostic cannot be run on an operational switch. You must disable the switch using the
chassisDisable command before you can run this test. After the command completes, the ATTN LEDs
flash amber, indicating that the command has finished and exited. Enable the switch using the
chassisEnable command to set the ATTN LEDs back to black.

NOTES

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.

OPERANDS

This command has the following operands:

slot

Tests all GbE ports in the specified slot. This operand is optional; if omitted, all
GbE ports are tested. This operand is valid only on chassis-based platforms.

all

Tests all ports on the switch.

EXAMPLES

To test the LEDs on slot 4 of Brocade DCX with an FX8-24 blade.

switch:admin> fcipledtest 4

PASSED.