Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 371)

Fabric OS Command Reference 341
53-1003131-01
fcrIclPathBWMonitor
2
fcrIclPathBWMonitor
Sets or displays FC Router ICL bandwidth monitor parameters for EX_Ports.
SYNOPSIS
fcriclpathbwmonitor --enable
fcriclpathbwmonitor --disable
fcriclpathbwmonitor --show
fcriclpathbwmonitor --help
DESCRIPTION
Use this command to enable or disable the Inter Chassis Link (ICL) EX_Ports bandwidth Monitor feature
on an FC Router, or to display the current status of ICL bandwidth feature and the ICL slot bandwidth
assigned to connected edge fabrics. If no operands are specified, this command displays the usage. By
default, this feature is disabled.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
--enable
Enables the ICL EX_Port bandwidth Monitor feature on an FC Router. In the
enable mode, FC Router will periodically check for bandwidth imbalances from
each ICL slot of FC Router to each ICL slot of neighbor switch connected through
EX_Ports. A RASLog message will be generated when bandwidth imbalance is
detected or resolved to other fabric.
--disable
Disables the ICL EX_Port bandwidth Monitor feature on an FC Router.
--show
Displays the current ICL EX_Port bandwidth Monitor feature status and bandwidth
from each slot to connected edge fabric.
--help
Displays the command usage.
EXAMPLES
To enable ICL EX_Port bandwidth Monitor:
fcr:admin> fcriclpathbwmonitor --enable
ICL bandwidth balance Monitor functionality is enabled
To disable ICL EX_Port bandwidth Monitor:
fcr:admin> fcriclpathbwmonitor --disable
ICL bandwidth balance Monitor functionality is disabled