Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 1143)

Fabric OS Command Reference 1113
53-1003131-01
switchShow
2
switchShow
Displays switch and port status.
SYNOPSIS
switchshow
switchshow [-slot slot] [-portname | -qsfp]
switchshow [-portcount]
DESCRIPTION
Use this command to display switch, blade, and port status information. Output may vary depending on
the switch model.
When used without operands, switchShow displays the following information:
switchName
Switch name.
switchType
Switch model and revision numbers.
switchState
Switch state: Online, Offline, Testing, or Faulty. When you issue the
switchcfgPersistentDisable command followed by the switchEnable
command, the switch state changes to, "Online (Temporary)". The switch remains
in this state until you issue the switchcfgPersistentEnable command.
switchMode
Switch operation mode: Access Gateway (if AG is enabled).
switchRole
Switch role: Principal, Subordinate, or Disabled.
switchDomain
Switch domain ID: 1 to 239.
switchId
Switch embedded port D_ID.
switchWwn
Switch world wide name (WWN).
switchBeacon
Switch beaconing state: On or Off.
zoning
The name of the active zone is displayed in parentheses. Active only when
Access Gateway mode is disabled.
FC Router
FC Router state: On or Off.
FC Router BB Fabric ID
The backbone fabric ID for FC routing.
Fabric Name
The name assigned to the fabric. The fabric name is set with the fabricName
command.
HIF Mode
Indicates HIF mode of the switch. Values are ON or OFF. The HIF mode can be
set using the configure command.