Watlow Series F4S/D - Manual (Page 58)

5 . 1 0 ■ S e t u p Wa t l o w S e r i e s F 4 S / D
Setup Page Parameter Table
Modbus
Register
Range read/write Conditions for
Parameter Description (Modbus Value) Default (I/O, Set, Ch) Parameters to Appear
✔ NOTE:
Press the Information Key
ˆ for more task-related tips.
Active: Always. 3000-3009
3010-3019
3020-3029
3030-3039
r/w
DIGIT IN1
(ASCII Values)
Name
Name the input for
easy reference.
Main > Setup > Digital Input x (1 to 4)
Digital Input x (1 to 4)
Active if Input 3 is not set to off
and Deviation Cascade is
selected.
1927 r/w — Depends on sensor and
decimal point selec-
tion.
Cascade High Range,
Deviation
Active if Input 3 is not set to off
and Deviation Cascade is
selected.
1926 r/w — Depends on sensor and
decimal point selec-
tion.
Cascade Low Range,
Deviation
Active if Input 3 is not set to off
and Process Cascade is selected.
1927 r/w — Depends on sensor and
decimal point selec-
tion.
Cascade High Range,
Process
Active if Input 3 is not set to off
and Process Cascade is selected.
1926 r/w — Depends on sensor and
decimal point selec-
tion.
Cascade Low Range,
Process
Active if Analog Input 3 is not set
to Off (variable selection only).
1925 r/w No Cascade
(0)
No Cascade (0)
Process Cascade (1)
Deviation Cascade (2)
Cascade
Select whether to
use the cascade
algorithm.
Active: Always. Input
607 [1]
617 [2]
627 [3]
r/w
Self Clear (0) Self Clear (0)
Latch (1)
Error Latch
Select whether error
clear is automatic or
manual.
Active: Always. Input
604 [1]
614 [2]
624 [3]
r/w
0.0 (0)
1.0 if Decimal
is set to 0.0
and Sensor
Type is set
to Thermo-
couple or
RTD. (10)
-60.0 to 60.0
(-600 to 600)
Filter Time
Set the filter time
for input in seconds.
Active: Always. Input
605 [1]
615 [2]
625 [3]
r/w
0 -19999 to 30000 Calibration Offset
Compensate for sen-
sor errors or other
factors.
Active: Always, except when Cas-
cade is set to Process Cascade
or Deviation Cascade this is
masked for Analog Input 1.
Input
603 [1]
613 [2]
623 [3]
r/w
— Depends on sensor.
Set Point High Limit
Set limit for maxi-
mum set point.
Setup Page Parameter Table
Modbus
Register
Range read/write Conditions for
Parameter Description (Modbus Value) Default [I/O, Set, Ch] Parameters to Appear