Watlow Series F4S/D - Manual (Page 107)

✔ NOTE:
For more information about how parameter settings affect
the controller’s operation, see the Features Chapter.
Wa t l o w S e r i e s F 4 C a l i b r a t i o n ■ 9 . 1
Chapter Nine: Calibration
Thermocouple Input Procedure . . . . . . . . . . . . . . . .9.2
RTD Input Procedure . . . . . . . . . . . . . . . . . . . . . . . .9.2
Voltage Process Input Procedure . . . . . . . . . . . . . .9.3
Current Process Input Procedure . . . . . . . . . . . . . .9.3
Process Output Procedure . . . . . . . . . . . . . . . . . . .9.4
Retransmit Output Procedure . . . . . . . . . . . . . . . . .9.5
Calibration Menu Map . . . . . . . . . . . . . . . . . . . . . . .9.6
Factory Page Parameter Table . . . . . . . . . . . . . . . .9.7
Overview
The Calibration Menu on the Factory Page allows
calibration of inputs and outputs. Calibration pro-
cedures should be done only by qualified technical
personnel with access to the equipment listed in
each section.
Before beginning calibration procedures, warm up
the controller for at least 20 minutes.
Restore Factory Values
Each controller is calibrated before leaving
the factory.
If at any time you want to restore the
factory calibration values, use the last parameters
in the menu: Restore In x (1 to 3) Cal. Press . .
No special equipment is necessary.
✔ NOTE:
To see how all the pages, menus and parameters are
grouped, refer to the inside back cover of this manual.
9