Watlow Series F4S/D - Manual (Page 48)

Active if controller is set to Dual
Channel Ramping (Channel 2).
4062 r/w 75 (75) Set Point 2 Low Limit
to Set Point 2 High
Limit
Enter Channel 2 Idle Set
Point
Select the channel 2
set point to be main-
tained after the pro-
file ends.
Active: Always (Channel 1). 4061 r/w 75 (75) Set Point 1 Low Limit
to Set Point 1 High
Limit
Enter Channel 1 Idle Set
Point
Select the channel 1
set point to be main-
tained after the pro-
file ends.
Main > Profiles > Edit Profile > Profile x (1 to 40) > Edit Step / Step x (1 to 256) > Step > End > Idle
Idle
✔ NOTE: Two sets of Modbus registers contain profile informa-
tion: In edit mode, the number of the profile being edited is at
4000, and the number of the step being edited is at 4001. When
the profile is running, the number of the profile being run is at
4100, and the number of the step being run is at 4101. All run
addresses are read only.
4 . 1 6 ■ P r o f i l e P r o g r a m m i n g Wa t l o w S e r i e s F 4 S / D
Profiles Page Parameter Table
Modbus
Register
Range read/write Conditions for
Parameter Description (Modbus Value) Default [I/O, Set, Ch] Parameters to Appear
✔ NOTE: Press the Information Key ˆ for task-related tips.