Watlow CPC400 - Manual (Page 31)

CPC400 Series User’s Guide Chapter 2: Installation
Doc. 0600-2900-2000 Watlow Anafaze 17
To remove the TB50 from the rail, use a flathead screw
driver to unsnap the bracket from the rail. See Figure 2.7.
Figure 2.7 TB50 Mounted on DIN Rail (Side)
Mounting with Standoffs
1. Remove the DIN rail mounting brackets from the
TB50.
2. Choose a location with enough clearance to remove the
TB50, its SCSI cable and the controller itself.
3. Mark the four mounting holes.
4. Drill and tap four mounting holes for #6 (3.5 mm)
screws or bolts.
5. Mount the TB50 with four screws or bolts.
There are four smaller holes on the terminal board. Use
these holes to secure wiring to the terminal block with tie
wraps.
Figure 2.8 Mounting a TB50 with Standoffs
Removal
Catch for
Screwdriver
DIN Rail
Snap Latch
Hook Side
3.4 in
(86 mm)
3.6 in
(91 mm)
2.6 in
(66 mm)
(18 mm)
0.2 in
(5 mm)
0.2 in
(5 mm)
SCSI Connector
0.2 in
4 Holes for
0.7 in
(5 mm)
#6 (3.5 mm)
Bolts or Screws