Watlow CPC400 - Manual (Page 15)

Doc. 0600-2900-2000 Watlow Anafaze 1
1
System Overview
Manual Contents
This manual describes how to install, set up, and operate a
CPC400 series controller. Each chapter covers a different as-
pect of your control system and may apply to different users:
• Chapter 1: System Overview provides a component
list and summary of features for the CPC400 series
controllers.
• Chapter 2: Installation provides detailed instruc-
tions on installing the CPC400 series controller and its
peripherals.
• Chapter 3: Operation and Setup provides instruc-
tions about operating and setting up the CPC400.
• Chapter 4: Tuning and Control describes available
control algorithms and suggestions for applications.
• Chapter 5: Menu and Parameter Reference pro-
vides detailed descriptions of all menus and parame-
ters for controller setup and for accessing parameter
and I/O values with a LogicPro program or via the se-
rial communications interface.
• Chapter 6: Troubleshooting and Reconfiguring
includes troubleshooting, upgrading and reconfigur-
ing procedures for technical personnel.
• Chapter 7: Specifications lists detailed specifica-
tions of the controller and optional components.
• Appendix: Modbus Reference describes the Mod-
bus RTU communications protocol, which is used to
read and set parameter values through the serial com-
munications interface. This information is intended
for programmers writing software to communicate
with the CPC400.
• Parameter Address Reference provides a way to
quickly locate parameter addresses.