Watlow CPC400 - Manual (Page 135)

CPC400 Series User’s Guide Chapter 5: Menu and Parameter Reference
Doc. 0600-2900-2000 Watlow Anafaze 121
Figure 5.4 Linear and Nonlinear Outputs
Alarms Menu
Use the Alarms menu to configure high alarms, low
alarms, and deviation alarms, including:
• Alarm set points
• Alarm outputs
• Alarm behavior
• Alarm hysteresis
• Alarm delay
Alarm High Set Point
Enter the set point at which the high alarm activates. The
high alarm activates if the process variable rises above this
value. For more information about the high alarm, see
Alarm High and Alarm Low on page 66.
Values: For a thermocouple or RTD input, any value with-
in the input range (see Table 5.7 on page 104). For a pro-
cess or pulse input, any value between the Input range low
and Input range high parameters.
Default: 1000. Decimal placement depends upon the Input
type and Disp format settings.
Modbus Address (Loops 1 to 9): 40307 to 40315
Parameter Number: 18
LogicPro Driver: Database
LogicPro Address (Loops 1 to 9): 18.1 to 18.9
Decimal Placement for Modbus or LogicPro: See Dec-
imal Placement for Numeric Values on page 80.
Actual Output
0
20
40
60
80
100
PID Calculation
10
20
30
40
50
60
70
80
90
3
8
13
27
48
62
2
4
7
12
29
44
66
Linear
Curve 1
Curve 2
36
19 19
79
l01 Alarms r
Other menus
l01 Alarm high r
SP b 1000 ˚F