Watlow CPC400 - Manual (Page 146)

Chapter 5: Menu and Parameter Reference CPC400 Series User’s Guide
132 Watlow Anafaze Doc. 0600-2900-2000
Keypad Test
To test the keypad, press <. This screen will appear:
To test a key, press it. If the key is working properly, an
icon for that key appears.
When you are done testing the keypad, press >> to return
to the Keypad test parameter.
Test Digital Output 1 to 35
Use the Test D/O parameter to manually toggle a digital
output on and off. Choose on to sink the current from the
output to the controller common. Choose off to stop the cur-
rent flow. For instructions, see Digital Output Test on page
26. You cannot toggle an output that is enabled for control.
NOTE! When you exit the I/O tests menu, all outputs that
were forced on are turned off.
Values: off (0) or on (1)
Default: off (0)
Modbus Address (Digital Outputs 1 to 35): 40751 to
40785
Parameter Number: 47
LogicPro Driver: CPC400_Digital_Out
LogicPro Address (Digital Outputs 1 to 35): 1 to 35
Additional Parameters for Serial Communications
and LogicPro Programs
These parameters are available only for serial communica-
tions and LogicPro programs. They are not accessible
through the controller keypad.
Alarm Acknowledge
Indicates whether an alarm has been acknowledged. To ac-
knowledge an alarm, clear the bit for that alarm.
Table 5.19 shows which bit corresponds to each alarm. See
Bit-Wise Values on page 78 for information on reading or
setting this parameter.
This parameter is available only for serial communications
and LogicPro programs.
lKeypad test r
press d to begin
uu Ends test
key pressed=
lTest D/O 1 r
boff