Watlow CPC400 - Manual (Page 133)

CPC400 Series User’s Guide Chapter 5: Menu and Parameter Reference
Doc. 0600-2900-2000 Watlow Anafaze 119
44188 to 44196 (cool)
Parameter Number: 70 (heat) or 71 (cool)
LogicPro Driver: Database
LogicPro Address (Loops 1 to 9): 70.1 to 70.9 (heat) or
71.1 to 71.9 (cool)
Decimal Placement for Modbus or LogicPro: See Dec-
imal Placement for Percentage Values on page 80.
Heat/Cool Power Limit Time
Enter the duration of the power limit set at the previous
parameter, or choose continuous to keep the limit in effect
at all times.
If you choose a timed limit, the limit timer restarts when-
ever the controller powers up and whenever the loop
switches from manual to automatic mode.
Values: 1 to 999 minutes (1 to 999) or continuous (0). Val-
ues in parentheses are for serial communications and Log-
icPro.
Default: continuous (0)
Modbus Address (Loops 1 to 9): 44205 to 44213 (heat) or
44222 to 44230 (cool)
Parameter Number: 72 (heat) or 73 (cool)
LogicPro Driver: Database
LogicPro Address (Loops 1 to 9): 72.1 to 72.9 (heat) or
73.1 to 73.9 (cool)
Sensor Fail Heat/Cool Output
A loop will switch to manual mode at the specified output
power if one of the following conditions occurs while in au-
tomatic mode:
• A failed sensor alarm occurs, or
• The mode override input becomes active (see Mode
Override on page 99).
For most applications, this parameter should be set to 0%
for both heat and cool outputs.
Values: 0 to 100% (0 to 1000). Values in parentheses are
for serial communications and LogicPro.
Default: 0% (0)
Modbus Address (Loops 1 to 9): 44239 to 44247 (heat) or
44256 to 44264 (cool)
Parameter Number: 74 (heat) or 75 (cool)
LogicPro Driver: Database
LogicPro Address (Loops 1 to 9): 74.1 to 74.9 (heat) or
75.1 to 75.9 (cool)
Decimal Placement for Modbus or LogicPro: See Dec-
imal Placement for Percentage Values on page 80.
l01 HtPwr limitr
time bcontinuous
l01 Sensor failr
heat outputb 0%