Watlow CPC400 - Manual (Page 106)

Chapter 5: Menu and Parameter Reference CPC400 Series User’s Guide
92 Watlow Anafaze Doc. 0600-2900-2000
Operator Parameters
Use the operator parameters to change the set point, con-
trol mode or output power level.
Figure 5.1 Operator Parameter Navigation
Set Point
Enter the desired value for the process variable. The new
set point will take effect immediately when you save the
new value. The Set point parameter is not available if ratio
control or cascade control is enabled for the loop.
Values: For thermocouples and RTD inputs, same as the
input range (see Table 5.7 on page 104). For process and
pulse inputs, any value between the Input range low and
Input range high parameters in the Input menu.
Default: 25
Modbus Address (Loops 1 to 9): 40205 to 40213
Parameter Number: 12
LogicPro Driver: Setpoint
LogicPro Address (Loops 1 to 9): 1 to 9
Decimal Placement for Modbus or LogicPro: See Dec-
imal Placement for Numeric Values on page 80.
Mode
Choose the control mode for this loop.
Values: See Table 5.1
Default: manual (0)
Modbus Address (Loops 1 to 9): 40120 to 40128
Parameter Number: 7
LogicPro Driver: Database
LogicPro Address (Loops 1 to 9): 7.1 to 7.9
Cancel a change without saving.
Escape to the loop display.
Edit parameter values.
Save a value and go to the previous parameter.
Save a value and go to the next or previous loop.
Access the operator parameters (from the loop display).
Save a value and go to the next parameter. .
,
><
p
x
l01 Set point r
b 25 ˚F
l01 Mode r
bmanual