Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 230
Chapter 9 Maintenance
9-21
(2)
Remove the retaining screws (7) on the rear cover
(3)
Remove the setscrew (1) on the circuit board chassis.
(4)
Open the circuit board chassis, it’s turn left to right.
(5)
Disconnect the Backlight Unit cable from the connector on the inverter board, and then remove the cable
from the cable clamp.
• Do not let the attachment screws fall inside the GP, or lose them
•
The Setscrews are not attached to all DC model of GP.
• A hot circuit board chassis can burn you. Be sure the chassis has cooled completely
prior to replacing the backlights.
Screws
Screws
Setscrew
Circuit board chassis
Connector
Cable clump
Cable
This manual is related to the following products:
- AGP3400 - 7.5 DIO HMI" AGP3300 - 5.7 DIO HMI" AGP3600 - 12.1 FLEX Network HMIs" AGP3500 - 10.4 FLEX Network HMI" AGP3400 - 7.5 FLEX Network HMI" AGP3600 - 12.1 CANopen HMI" AGP3500 - 10.4 CANopen HMI" AGP3400 - 7.5 CANOpen HMI" AGP3300 - 5.7 CANopen HMI" AGP3300H - 5.7 Handheld HMIs" AGP3750 - 15 Multi-Media HMI" AGP3650 - 12.1 Multi-Media HMIs" AGP3550 - 10.4 Multi-Media HMIs" AGP3450 - 7.5 Multi-Media HMI" AGP3360 - 5.7 Multi-Media HMI" AST3300 - 5.7 Basic HMI" AST3200 - 3.8 Basic HMI" AGP3600 - 12.1 Standard HMIs" AGP3500 - 10.4 Standard HMIs" AGP3400 - 7.5 Standard HMI" AGP3300 - 5.7 Standard HMI" AGP3200 - 3.8 Standard HMI"