Proface AGP3500 - 10.4 DIO HMI" - Manual

1/10
ST and GP Series
ATEX Instruction Guide
Concerning the use of ST and GP Series Graphic Panels for
applications in potentially explosive atmospheres
(Zones 2/22, equipment category 3 Gas Dust)
Digital Electronics Corporation
8-2-52 Nanko Higashi, Suminoe-Ku,
Osaka, 559-0031 JAPAN
Type examination certificate: INERIS 07ATEX3003X and
Additions 01/02
S
AFETY
I
NSTRUCTIONS
Read these instructions carefully, and look at the equipment to become familiar
with the device before trying to install, operate, or maintain it. The following
special messages may appear throughout this documentation or on the
equipment to warn of potential hazards or to call attention to information that
clarifies or simplifies a procedure.
The addition of this symbol to a Danger or Warning safety
label indicates that an electrical hazard exists, which will result
in personal injury if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
DANGER indicates an imminently hazardous situation, which, if
not avoided, will result in death or serious injury.
DANGER
The information in this document is subject to change without notice.
Copyright © 2013.11 Digital Electronics Corporation.
All Rights Reserved.
PFX134172C .GP-ATEX-IS-MT03
Printed in China
www.pro-face.com