3 interface specifications, 3 interface specifications -35 – Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 100
Chapter 4 Specifications
4-35
4.3.3
Interface Specifications
This section describes the specifications of each interface of the GP Series unit.
Serial Interfaces
Serial Interface (COM1)
This interface is used to connect an RS232C/RS422/RS485 serial cable. A D-sub 9-pin plug connector is
used.
Communication method is switched via software
• For instructions on how to connect to other devices, always refer to the “GP-Pro EX
Device/PLC Connection Manual”.
• Always connect the #5 SG (Signal Ground) of the GP unit to the connected device,
especially if the connected device is also not isolated. Failure to do so may damage
the RS232C/RS422/RS485 circuit.
• When connecting an external device to the GP using the SG terminal, be sure to
check that no short-circuit loop is created when you setup the system.
•
When isolation is necessary, you can use either RS232C isolation unit (CA3-ISO232-01) on
COM1 or RS485 isolation unit (CA3-ISO485-01) on COM2.
GP Connector
XM2C-0942-502LX
Interfit Bracket
#4-40(UNC)
Recommended Cable Connector
XM2D-0901
Recommended Cable Cover
XM2S-0913
Recommended Jack Screw
(#4-40 UNC)
XM2Z-0073
- AGP3400 - 7.5 DIO HMI" AGP3300 - 5.7 DIO HMI" AGP3600 - 12.1 FLEX Network HMIs" AGP3500 - 10.4 FLEX Network HMI" AGP3400 - 7.5 FLEX Network HMI" AGP3600 - 12.1 CANopen HMI" AGP3500 - 10.4 CANopen HMI" AGP3400 - 7.5 CANOpen HMI" AGP3300 - 5.7 CANopen HMI" AGP3300H - 5.7 Handheld HMIs" AGP3750 - 15 Multi-Media HMI" AGP3650 - 12.1 Multi-Media HMIs" AGP3550 - 10.4 Multi-Media HMIs" AGP3450 - 7.5 Multi-Media HMI" AGP3360 - 5.7 Multi-Media HMI" AST3300 - 5.7 Basic HMI" AST3200 - 3.8 Basic HMI" AGP3600 - 12.1 Standard HMIs" AGP3500 - 10.4 Standard HMIs" AGP3400 - 7.5 Standard HMI" AGP3300 - 5.7 Standard HMI" AGP3200 - 3.8 Standard HMI"