Proface AGP3500 - 10.4 DIO HMI" - Manual

1
USB-Serial (RS-232C)
Conversion Cable
Installation Guide
This product is a conversion cable for using
an USB I/F of the Unit (any models of the
“Corresponding Units” described in this
guide) as the Serial (RS-232C) I/F.
• When using this product with GP/ST/
LT Series, there are some restrictions
for the external devices connecting to
the Serial (RS-232C) I/F side of this
product. For details, please refer to the
following manuals;
• Pro-face Home Page
URL: http://www.pro-face.com/otasuke/
Safety Precautions
• Do not disassemble or remodel this
cable in any way. Doing so may cause
an electric shock or fire.
• Do not use this cable in areas where
flammable gases are present. Doing
so may cause an explosion.
„ To Prevent USB-Serial (RS-232C)
Conversion Cable Damage
• Do not use the USB-Serial (RS-232C)
Conversion Cable at temperatures out-
side the range specified in this guide.
• Do not use or store this cable at very high
temperatures.
• Do not use or store this cable in direct
sunlight or excessively dusty or dirty
environments.
• Do not use or store this cable in an envi-
ronment where it may be exposed to
chemical vapors or fumes.
• Do not allow water to enter the connector.
Also, do not touch the connector if your
hands are wet. Doing so may cause an
electric shock.
• Do not connect or disconnect the USB-
Serial (RS-232C) Conversion Cable dur-
ing data transfer. Doing so may cause a
data communication error.
„ Unit Disposal
• When the product is disposed of, it should
be done so according to your country's
regulations for similar types of industrial
waste.
Package Contents
(1) USB-Serial (RS-232C) Conversion Cable
(1) (CA6-USB232-01)
(2) Cable Clamp (1 set)
(Holder: 1, Clamp 1)
Hold the Serial connector, then peel the
seal of the holder’s bottom.
(3) Installation Guide
This product has been carefully packed, with
special attention to quality. However, should
you find anything damaged or missing,
please contact your local distributor
immediately.