Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 222
Chapter 9 Maintenance
9-13
(6)
Disconnect the Backlight Unit cable from the connector on the inverter board, and then remove the cable
from the cable clamp.
(7)
Remove the setscrew from the Backlight Unit.
(8)
Remove the Backlight Unit while sliding it along the groove.
(9)
Insert a new Backlight Unit while sliding it along the groove.
•
Use the Phillips sTcrewdriver No.1.
• Be careful that no dust or dirt adheres to the backlight surface or to the backlight
holder.
• Be careful not to soil the Backlight with moisture, oil content or finger prints;
otherwise, the life duration of the Backlight will be shortened.
Connector
Cable Clamp
Cable
setscrew
Backlight Unit
This manual is related to the following products:
- AGP3400 - 7.5 DIO HMI" AGP3300 - 5.7 DIO HMI" AGP3600 - 12.1 FLEX Network HMIs" AGP3500 - 10.4 FLEX Network HMI" AGP3400 - 7.5 FLEX Network HMI" AGP3600 - 12.1 CANopen HMI" AGP3500 - 10.4 CANopen HMI" AGP3400 - 7.5 CANOpen HMI" AGP3300 - 5.7 CANopen HMI" AGP3300H - 5.7 Handheld HMIs" AGP3750 - 15 Multi-Media HMI" AGP3650 - 12.1 Multi-Media HMIs" AGP3550 - 10.4 Multi-Media HMIs" AGP3450 - 7.5 Multi-Media HMI" AGP3360 - 5.7 Multi-Media HMI" AST3300 - 5.7 Basic HMI" AST3200 - 3.8 Basic HMI" AGP3600 - 12.1 Standard HMIs" AGP3500 - 10.4 Standard HMIs" AGP3400 - 7.5 Standard HMI" AGP3300 - 5.7 Standard HMI" AGP3200 - 3.8 Standard HMI"