Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 160)

Chapter 5 DIO Connector
5-7
(3) The adjacent wire insertion hole (round-shaped hole) will be in an open state.
With the slot screwdriver inserted, insert the wire into the wire insertion hole (round-shaped hole).
(4) Remove the slot screwdriver from the tool insertion hole (square-shaped hole). The wire insertion hole
(round-shaped hole) will close and the wire will be secured. For wire removal, remove the desired wire
by inserting a slot screwdriver into the corresponding tool insertion hole (square-shaped hole) following
procedures (1) and (2).
(5) Insert the wired DIO connector straight into the DIO I/F of the GP unit.
• Be sure to strip only the amount of wire cover required. If too much cover is
removed, the end wires may short against each other, or against an electrode, which
can create an electric shock. If not enough cover is removed, the wire cannot carry a
charge.
• Do not solder the wire itself. This could lead to a bad or poor contact.
• Insert each wire completely into its opening (round-shaped hole). Failure to do so
can lead to a unit malfunction or short, either against wire filaments, or against an
electrode.
• When wiring, be aware of the installation position, direction, and twisting of the
wiring as to not develop stress on the connector. Fix the cable near the GP by cable
clamp and set it loosely as to not place tension on the connector.
Screwdriver
Wire
Wire insertion hole
(Round-shaped hole)
Tool insertion hole
(Square-shaped hole)