Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 215)

GP3000 Series Hardware Manual
9-6
9.4 Replacing the Backlight
9.4.1 AGP-35
∗0T
• The backlights of the following GP cannot be replaced by the user. When the
backlight needs to be replaced, please contact your local GP distributor.
- GP-3200 Series, GP-3300 Series, GP-3400 Series
- AGP-3500L
- AGP-3500T / AGP-3550T Series which is marked on Rev.5
- AGP-3650U
- AGP-3600-U1-D24-CA1M
- AGP-3600T / AGP-3650T / GP-3700 Series which is marked on Rev.5
• If the status LED continues turning ON in Orange after the backlight replacement,
GP unit malfunction may be occurred. Please contact your local GP distributor.
• Use the following table to check that you have ordered the correct backlight.
GP Rev
*1
Backlight
Model
Attachment Procedures
AGP-3500T
AGP-3550T
-
CA5-
BLU10T-01
SEE
„
CA5-BLU10T-01 (page 9-7)
Rev.5 is
marked. Not user replaceable. When replacement is
required, contact your local GP distributor.
Rev.2 is
marked.
CA6-
BLU10T-02
SEE
„
CA6-BLU10T-02 (page 9-11) AGP-3510T
AGP-3560T
-
*1 The revision number of the GP is shown in the label affixed to the
GP. In the example shown below, an asterisk "*" is displayed in the
position where "2" should be, meaning "Rev.2".