IAI America ERC2 - Manual (Page 60)

3. W
iring
37
3.4.2 Address Assignment
If multiple axes are connected, a slave number must be assigned to each axis so that the host can recognize the
corresponding actuator.
Assign addresses in the setting screen of the teaching pendant or PC.
z Overview of operation on the PC
[1] Open the main window o [2] Click Setup (S) o [3] Bring the cursor to Controller Setup (C) o [4] Bring the
cursor to Assign Address (N) and click the mouse o [5] Enter an appropriate number in the address table.
z Overview of operation on the teaching pendant RCM-T
[1] Open the User Adjustment screen o [2] Use the d key to bring the cursor to Address No. o [3] Enter an
appropriate address and press the ENTER key o [4] Enter “2” under Adjustment No. and press the ENTER
key
z Overview of operation on the simple teaching pendant RCA-E
[1] Open the User Adjustment screen o [2] Press the ENTER key to open the screen showing Address No. o [3]
Enter an appropriate address and press the ENTER key o [4] Enter “2” under Adjustment No. and press the
ENTER key
Refer to the operation manual for the teaching pendant or PC software for the specific operating procedure.
Caution: In the actual process of assigning addresses, the teaching pendant or PC and the target actuator
must have a one-on-one link. Therefore, disconnect the communication cables (SGA/SGB) from
other axes to tentatively provide a condition where not more than one axis is connected.