IAI America ERC2 - Manual (Page 43)

2. Installation
20
2.2.3 Installing the Load
z Slider Type
Four tapped holes are provided in the slider, so
affix the load using these holes (indicated by
arrows in the figure shown to the left).
Type Slider mounting hole
SA6C, SA7C M5, depth 9 mm
Nominal thread size Tightening torque
Bolt bearing surface: steel Bolt bearing surface: aluminum
M5 7.3 N‚m (0.74 kgf‚m) 3.4 N‚m (0.35 kgf‚m)
The affixing method of the load shall conform to the installation method of the actuator.
In an application where the actuator is moved with the slider fixed, install the load using the tapped holes in the slider
in the same manner.
The slider has two reamed holes. Use these holes when high repeatability is required for load installation/removal.
When fine-tuning the squareness of the load, etc., make adjustment by using one of these two reamed holes in the
slider.
Type Reamed hole
SA6C, SA7C I 5, H10, depth 10 mm