Using presets – Extron Electronics MTPX Plus 6400 Series User Guide User Manual
Page 47
b.
One at a time, press and release the output 5 through 8 buttons.
O
U
T
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
Press the buttons.
The selected buttons light green.
7.
Exit I/O Group mode: Simultaneously press and release the Video button and Audio
button.
NOTE: If you do nothing for approximately 30 seconds, the front panel times out
and the switcher exits I/O Group mode.
In this example:
z
z
Group 1 consists of inputs 1 through 4 and outputs 1 through 4.
z
z
Group 2 consists of inputs 5 through 8 and outputs 5 through 8.
Using Presets
The current configuration (configuration 0) can be saved as a preset in any one of 64 global
preset memory addresses. Each preset is assigned to an input button and are available to be
either saved or retrieved from the front panel. When a preset is retrieved from memory, it
becomes the current configuration.
NOTES:
•
Presets cannot be viewed from the front panel unless recalled as the current
configuration. Presets can be viewed using the Extron
•
The current configuration and all presets are stored in non-volatile memory.
When power is removed and restored, the current configuration is still active
and all presets are retained.
•
When a preset is recalled, it replaces the current configuration, which is lost
unless it is also stored as a preset. The recalled preset overwrites all of the
current configuration ties in favor of the preset configuration ties.
MTPX Plus 6400 Series Matrix Switchers • Operation
41