Extron Electronics MTPX Plus 6400 Series User Guide - Manual (Page 135)

Creating or deleting a tie
Make or break a tie as follows:
1. Click the Video Only , Audio Only , or Video & Audio button to select video, audio,
or both for switching (audio follow or audio breakaway). Each mouse click on a button
toggles the other two buttons off.
2. Move the mouse over the matrix of input and output selection buttons. Click a button
to:
z z Create a pending tie (if a tie does not exist) of the input and output associated with
that button.
z z Create a pending untie (if a tie exists) of the input and output associated with that
button.
A “P” (for pending) appears in the button.
NOTES: • Because of command length limitations in the browser, you can make a
maximum of 30 connections with a single Take command (step 2).
• If you lose track of the input and output associated with a specific
button, let the mouse rest over one of the tie buttons for a moment. A
field pops up (as shown on figure 67) that identifies the input and output
for that button.
• To tie an input to all outputs, click the input number for that input.
3. Click the Take button to make the configuration changes or the Cancel button to
abandon the configuration changes.
MTPX Plus 6400 Series Matrix Switchers • HTML Operation 129